Operating instructions

50
7.6 DESIGN ELEMENT MOUNTING
Installing the
done by snapping it over the integra
finger scanner as follows: using two
fingers, grab the
on the sides from the middle.
and insert the
bottom two notches in the scanner
two bottom holes.
While the bottom edge of the
design element
apply little pressure on the top face
towards the scanner forming a little
curve (avoid bending the plate).
While in this position, align the
notches on the top edge of the
design element
two top holes. Once seated r
your fingers and the
element
is in place.
7.7 DESIGN ELEMENT DISMOUNTING
In order to dismount the design
element, use a flat object (flat
screwdriver or the like) and lift the
design element
carefully, by placing the flat
in-
between the upper or the lower
edge of the plastic housing and the
design element
Installing the
design element is
done by snapping it over the integra
finger scanner as follows: using two
fingers, grab the
design element
on the sides from the middle.
Align
and insert the
design element
bottom two notches in the scanner
two bottom holes.
While the bottom edge of the
design element
is in this position,
apply little pressure on the top face
towards the scanner forming a little
curve (avoid bending the plate).
While in this position, align the
notches on the top edge of the
design element
into the scanner
two top holes. Once seated r
elease
your fingers and the
design
is in place.
In order to dismount the design
element, use a flat object (flat
screwdriver or the like) and lift the
design element
out of the frame
carefully, by placing the flat
object
between the upper or the lower
edge of the plastic housing and the
design element
.