Installation & Assembly

WOOD VENEER CEILING MEDALLION
installation instructions:
quick dry construction adhesive
pneumatic nail gun
small pin nails
premium wood stain OR premium paint
paint brush/roller
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• Clean the installation surface and back of medallion of
any debris with a dry, clean cloth.
• It is highly recommended to attach these ceiling
medallions into studs or secure structure in the ceiling or
wall where installing.
• It is highly recommended that you paint or stain before
installing.
• Use the pin nails to hold medallion up while glue cures.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Medallions are not load‐ bearing. Do not use them to support electrical xtures or ceiling fans.
IMPORTANT NOTE:
When installing medallions with a light xture
or ceiling fan turn the power off at the breaker
before installation. Medallions are solely decora-
tive. Do not use medallions to support the light
xture or fan. Do not use the xture or xture
canopy to support the medallion. To ensure all
electrical codes are met, make sure to consult
with a licensed electrician.
MEDALLION INSTALLATION WITH A LIGHT FIXTURE OR CEILING FAN
1. Disconnect and remove current xture before installing the medallion
(if a current xture is already installed).
2. Feed the electrical wiring through the medallion’s center hole and gently press
the medallion up against the ceiling.
3. All medallions will need to be installed with small pin nails to hold while glue
cures.
4. Re‐connect the ceiling xture or ceiling fan following the manufacturer’s
guidelines.
MEDALLION INSTALLATION WITHOUT A LIGHT FIXTURE OR CEILING FAN
1. Gently press the medallion up against the ceiling or wall.
2. All medallions will need to be installed with small pin nails to hold while glue
cures.
We Can Help. Call [phone]
www.ekenamillwork.comIndustry leading manufacturer of urethane, PVC, wood, rustic, and metal millwork
ADHESIVE
ADHESIVE
For wall installation you can use adhesive and/or heavy duty double stick tape/strips.
Tack up with pin nails or hold until glue cures. Certain designs may allow for claw or
cleat hanging brackets to be attched on backside.