Installation Guide

10) Nail column to post ONLY
ON THE BOTTOM . Do not at-
tach at center or top (to allow for
expansion).
11) Apply adhesive to mitered
edges of base moulding and wrap
around bottom of column shaft.
12) Fasten joints on base with pin-
nails.
13) The TOP of the shaft should
NOT be fastened to the post and
there should be at least 1/2” gap to
allow expansion (see step 2).
14) Install cap, repeating steps 11
and 12.
15) Caulk edges of base, cap, and
nail holes.
1) Clean surface of column with
cleaner recommended by the paint
manufacturer. (Do not use sol-
vents). Allow to dry completely,
then paint with 2 coats of acrylic
latex paint. Warning: using dark
colors might cause excessive
thermal expansion.
Please note the correct assembly of the E-Z Lock joint
shown at the left. Nails MUST be installed only in the edg-
es shown (3 and 4). Installing on the other edges may re-
sult in open seams.
1) Glue both joint edges; slide first joint together
2) Push second joint closed
3) Nail this joint first
4) Nail this joint second
Notes:
Always use non-corrosive fasteners — galvanized, stain-
less steel, etc. for exterior installations, and always follow
glue and paint manufacturer’s instructions.
*Column must not be allowed to collect water, debris, etc.
If the top of the column extends beyond the soffit/beam,
the cap must be flashed with lead, copper, aluminum, etc.
to prevent entry of water or foreign materials.