Installation Guide

Faux Wood Flex Beam Strap
installation instructions:
tape meausure, straight edge
adhesive (for bonding to rubber)
pen or sharpie
scissors or shears
utility knife
hammer or nail gun
nails
STEP BY STEP
INSTRUCTIONS
TOOL & MATERIAL
CHECKLIST
SPECIAL INSTRUCTIONS
AND NOTES
EXAMPLE
INSTALLATION DIAGRAMS
• Cut strap to required length to wrap around the three sides of your beam.
• Depending on your installation method, you will have to choose the correct
adhesive, but we recommend a quality instant adhesive for rubber bonding.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear proper protective gear.
Follow power tool and adhesive instructions, and user manuals.
Use common sense and follow good construction practices.
1. Measure the width of the beam.
2. Cut the strap to t. Bend the strap around the
beam and nd the corners.
3. Cut 3 pieces at 45 degree angle and glue with
edges butted up to each other OR bend and nail ¼”
from radius bend.
NOTE: Use clear heavy duty gorilla glue or black
construction adhesive to adhere mitered pieces .
4. Apply a bead of construction adhesive to the back
of the strap. Do not apply adhesive near the edge.
5. Fit or fold the strap around the beam and make
sure the strap is square. Make any necessary cuts
as needed.
6. Place strap in desired location around the beam
and press rmly to adhere the adhesive. Nail strap
on bottom corners rst. Then nail one side and
then the other, until the strap is secure. At ground
level make sure the strap lays flat. Dot/color the
nail heads with a black permanent marker.
Industry leading manufacturer of urethane, PVC, wood, rustic, and metal millwork
1)
4)
5)
2)
3)
6)