Installation manual

6. Initial Installation Diamond digital
84
6.10.5 GENLOCK ADJUSTMENT WITH MENU
From software version ”G”, the mixers include the possibility to perform the genlock
adjustment of the individual input sources in Installation menu Config E-Box.
When adjusting the genlock phase, all sources have to be successively checked
for their timing by switching up on the bus Video store.
To adjust the genlock phase, select the softkey Config E-Box in the Install menu.
The following display is represented:
With controller Genlock, the phase relation of the mixer can be shifted by –1 line
up to +2 lines in comparison with the genlock reference signal.
The display TIMING serves for checking the timing of the sources.
The bar diagram arranged horizontally under the TIMING field displays the timing
of the source to the mixer that is selected on bus Video store.
The display can give the following informations:
No input signal in the
selected input.
Input signal does not lie in
area of the auto phasers.
Input signal IN03 lies 17.7 µs be-
fore the earliest mixer input.