Installation manual

6. Initial InstallationDiamond digital

6. INITIAL INSTALLATION

6.1 INSTALLATION CHECKLIST

Note The installation checklist comprises the procedures for installation and ini-

tial installation described in this manual. It is recommended to install the de-

vices with the aid of the instructions below.

Please note that the line voltage is only applied when you are expressively

requested in the checklist to do so.

• After having thoroughly unpacked the equipment and checked the packings for

mains cables and other small parts, check the delivery with regard to damages

caused by transport. If you note a damage, immediately inform the forwarding

agent.

Using the packing slip make sure that the delivery is complete.

• Before starting installation, read the enlosed installation instructions and be-

come familiar with the safety instructions.

• Mount the control panel into a desk.

• Mount the electronics box into an equipment cabinet.

• Check the plug-in cards in the E-box with regard to correct position in the sup-

port frame and make sure that the plug-in cards are locked.

• Set the switches and jumpers to the required operating position.

• Establish the earth connection.

• Make sure that the line voltage is conform with the voltage adjusted in the deliv-

ered equipment. If required, change it over to the corresponding line voltage.

• Set the service power switch on control panel and E-box to position ON.

• Establish Cheapernet cabling between control panel and E-box. Connect the

video input and output cables as well as the other control cables.

ATTENTION Cheapernet has to be terminated with a 50-Ω resistor!

• Connect the mains cable to the central mains distribution of the studio and

switch on power.

• Check the operational functions of the switcher.

• Adjust timing.