Installation manual

5. Connection and Startup Diamond digital
44
5.3 CONTROL DESK CONNECTOR PANEL
1
2
13
14 5
16 17
FloppyMouse Service Serial PortMonitorRemoteAC Power In
J1
J2 J3
J4 J5 J6 J7 J8
50 OHM
Fuse:
2 * 6,3A
AC - Line
Voltage
115V AC
230V AC
Attention: 50 Ohm cheapernet cable only!
Item
No:
Socket / Connector
Description
Socket type
Connector type
Function
1 J1
AC POWER IN
IEC-320, CEE-22 Convenience outlet for power supply to the
control panel. The convenience outlet contains
a mains filter as well as the two unit fuses.
Fuse rating: 2 x 6,3A slow-blow.
The factory-adjusted supply voltage is indi-
cated.
Caution
Double-pole or neutral fusing.
After operation of the protective device, parts of
the equipment that remain under voltage might
represent a hazard during servicing.
2 J2, J3
REMOTE
BNC / 50-ohms
(Loop-through/50-W) cheapernet connector for
connection between control panel and E-box or
further control units in the network.
For further information see the section ”Cheap-
ernet Specifications”.
Note:
In the latest version, only jack J2 is equipped.
For interconnection the signals a BNC-T-plug is
included.
3 J4
MONITOR
9-pin D-type
female
TTL interface for connecting an EGA data mon-
itor. The monitor serves for display of the
switcher menu if the control panel is not pro-
vided with a display (DD5 and DD10 only).
The monitor type suitable for use, depends on
the controller of the control panel:
– Controller RY1821: EGA monitor
– Controller RY1822: VGA monitor
For further information see the section ”Con-
necting a Monitor”.