Installation manual

8. DVE and Editors DD5, DD10, DD20, DD30
138
Mode 3
DVE effects
without FX Loop
Select the DVE key (DVE1 or DVE2 in case of DD20; DD30) on the Aux bus delega-
tion bank.
Disable Loop.
Disable DVE transition in the Transition panel (if enabled).
In this mode, the following signals can be switched to the DVE:
• all signals of the Aux bus; if a coupled key signal exists, this is sent to the DVE
as key signal.
• video signals and – if existing – the pertaining key signal from the respective
switching level.
If only a video signal and no key signal exists, 100 % white is sent to the DVE as
key signal.
If the DVE delegation key is held down, any signal may be selected as key signal.