Installation manual

8. DVE and EditorsDD5, DD10, DD20, DD30

133

8.3.6.2 Control of aux buses

Standard cable RS-422

Serial port: Port1 or port2 or port3

Protocol in switcher setup: DVE DPM-AUX

Enables: Key Edit Enable has to be active.

Port: SLAVE/MODEL100 port

Protocol: 200-1 or 200-2 protocol

Select in the Router menu AUX1, 2, 3 or 4 according to the table below:

Select video signal from the switcher as router

DVE1 AUX1

DVE2 AUX2

AUX3 AUX3

AUX4 AUX4

When switching the buses indicated above, the switcher transmits the coupling

point information to the DPM. The DPM keeps in mind this coupling point to that

side of the transformed picture being now visible. By 180

rotation of the picture and

selection of another coupling point, the latter is stored to the other side. When the

DVE now turns the picture, the DVE transmits commands to the switcher in order

that the switcher switches over the coupling point in time to transmit the ”other” side

to the DVE.

The tests are made with the DPM-700 Software Panel/Comm/Trans Version 2.4A.

Connection cable:

DD switcher setup

and installation:

DVE setups and

installations:

Functions:

Special features: