Installation manual

8. DVE and EditorsDD5, DD10, DD20, DD30
129
8.3.3 ABEKAS A57 WITH RS232 PROTOCOL
Connection cable:
Diamond
9-pin 9-pin
Abekas A57
2
3
8
2
5
4
4
7
TxD RxD
RxD
RTS
CTS
GND
TxD
GND
Note: Do not use this cable with the DD35!
DD switcher setup
and installation:
Serial port: RS-232 interface
– DD5/DD10 = port4
– DD20/DD30 = port 232
Protocol in switcher setup: DVE A53D
DVE setups and
installations:
Port Aux B.
Select RS-232 protocol for port Aux B.
Set header 2 on address port to RS-232 (Techn. Guide A57, Fig. 36)
Set into Slave control
For DVE effect gen-
eration please note:
No scaling required.
Possible
functions:
Sequence selection from switcher.
Sequence run with switcher fader.
Particularities: Only possible with 9600 Baud.