Installation manual

8. DVE and EditorsDD5, DD10, DD20, DD30
127
8.3 DEVICE SPECIFIC NOTES
8.3.1 PINNACLE PRIZM
Connection cable: Standard RS-422 cable
DD switcher setup
and installation:
Serial port: Port 1 or port 2 or port 3
Protocol in switcher setup: DVE PRIZM
DVE setups and
installations:
Enable RS-422 VTR.
For DVE effect gen-
eration please note:
Scaling to 30 seconds
(problem with DVEator as a result of limited storage capacity).
Possible
functions:
Sequence selection from DD switcher.
Sequence run with DD fader.
Particularities:
• Stored events (Freeze, GPI trigger, etc.)
may be lost during recalling.
• At present the DVE Aux buses cannot be remote controlled.
Pinnacle (2 channel):
• Each DVE requires its own port at the switcher.
This is easy to understand as each DVE can also be used as single-channel
DVE.
• The switcher cannot control both ports synchronously. Synchronous control is
possible with the controls at the DVEs.
With the switcher synchronous control is only possible with one wipe with
EXTRA (1 ME controls only the DVE without video function).
• The digital Pinnacle version does not permit a transition to a background.