User`s manual

30
Chapter3SettingMonitor
3-7. Enabling/Disabling DDC/CI communication
This function allows you to enable/disable the DDC/CI communication (see “7-4. Glossary” (page 46)).
Procedure
1. Press
to turn off the monitor.
2. Press
holding down to turn on the monitor.
You can toggle between Enable and Disable by performing steps 1 and 2.
Note
• You can check the DDC/CI setting in the <Information> menu.
• HDMI input does not support DDC/CI communication.
3-8. Resetting the Monitor to the Default Settings
<Reset>
There are two different Resets: Color Reset for only resetting the color adjustments to the default settings and
Full Reset for resetting all settings to the defaults.
Attention
• After resetting, you cannot undo the operation.
Note
• Regarding the default setting, see “Main Default Settings” (page 44).
●
To reset the color adjustments
This function only resets the color adjustments for the currently selected mode to the default settings.
Procedure
1. Choose <Color> from the Adjustment menu, and press
.
2. Choose <Reset> from the <Color> menu, and press
.
3. Select “Reset” with
or .
4. Press
.
The color adjustments revert to the default settings.
●
To reset all adjustments to the default settings
This function resets all adjustments to the default settings.
Procedure
1. Choose <Others> from the Adjustment menu, and press
.
2. Choose <Reset> from the <Others> menu, and press
.
3. Select “Reset” with
or .
4. Press
.
All adjustments revert to the default settings.