User`s manual

9
Chapter1Introduction
●
Rear
14
1210
11
13
16
15
10. Power connector Connectsthepowercord.
11. Input signal connector
Left:DisplayPortconnector/Center:DVI-Dconnector/Right:D-Submini15-pin
connector
12. USB port (UP) ConnectstheUSBcableforusingtheUSBHubfunction(page37).
13. Security lock slot ComplieswithKensington’sMicroSaversecuritysystem.
14. Stand
*2
Adjuststheheightandangle(tiltandswivel)ofthemonitor.
15. USB port (DOWN) ConnectsaperipheralUSBdevice.
16. Cable holder Coversthemonitorcables.
*2 An optional arm (or an optional stand) can be attached by removing the stand (see “6-1. Attaching the Optional Arm” (page 35)).
1-3. EIZO LCD Utility Disk
An “EIZO LCD Utility Disk” (CD-ROM) is supplied with this product. The following table shows the disk contents
and the overview of the software programs.
●
Disk contents and software overview
The disk includes software programs for adjustment, and User’s Manual. Refer to Readme.txt le on the disk
for software startup procedures or le access procedures.
Item Overview Windows Macintosh
Screenadjustmentpatternles Usedwhenadjustingtheimageofanalog
signalinputmanually.
√ √
ScreenManagerProforLCD
(DDC/CI)
Softwareforadjustingthescreenusingthe
mouseandkeyboard.
√ -
EIZOScreenSlicer Softwarethatdividesascreenandlaysout
multiplewindowsefciently.
√ -
User’sManualofthismonitor(PDFle) √ √
Readme.txtle √ √
●
To use “ScreenManager Pro for LCD (DDC/CI) / EIZO ScreenSlicer”
For the installation and use of “ScreenManager Pro for LCD (DDC/CI) / EIZO SceenSlicer”, refer to the
respective User’s Manual on the disk.