Operation Manual

32
Chapter 3 Troubleshooting
(HDMI Input Signal)
Problems Possible cause and remedy
1. No Picture
Power indicator does not light up.
Check whether the power cord is correctly connected.
Press
on the remote control or touch
of the
operation switch.
Power indicator lights in orange.
Switch the input signal with [INPUT SELECT]
( ) on
the remote control or of the operation switch.
Turn on the AV equipment.
Power indicator lights in blue. Check whether the AV equipment is properly connected
to the monitor.
Switch the setting using the <Field Rate> in the <Monitor
Settings>.
2. The message below appears. These messages appear when the input signal is incorrect
even if the monitor is functioning.
The frequency of the signal is outside the specication.
Example:
Conrm the digital signal format by referring to the
instruction manual of the equipment connected. (Refer to
page 35.)
3. The color shown on the display is not correct. • Change the color space of the video input signal using
<Color Space> in the <Monitor Settings> menu.
(Normally, select “Auto”.)
4. The video images are out of control by the FF/REW
operation when a video equipment is connected to
the monitor.
The monitor mechanism causes the image out of control
status a little. This is not a malfunction.
5.
No sound/Volume control is not available. Check whether the applicable format of the equipment
connected is correct.
Refer to page 35 for the sound input format of the
monitor.