User`s manual

2. CONNECTING THE eClient
630L/630L-N
This chapter explains how to connect the eClient 630L/630L-N to a WTS.
2-1. Setting up the eClient 630L/630L-N
Please observe the following cautions when connecting the 630L/630L-N.
WARNING
Place the eClient 630L/630L-N on a strong, stable surface.
A unit placed on an inadequate surface may fall, resulting in injury
or equipment damage. If the unit falls, disconnect the power
immediately and have the unit checked by a qualified service
engineer before using it again. Using a unit after it has been
dropped may result in fire or electric shock.
OK
Set the unit in an appropriate location.
Not doing so may result in fire, electric shock, or equipment
damage.
* Do not place outdoors.
* Do not place in the transportation system (ship, aircraft, trains,
automobiles, etc.)
* Do not place in a dusty or humid environment.
* Do not place in a location where the steam comes directly on the
screen.
* Do not place near heat generating devices or a humidifier.
2-2. Connecting the eClient 630L/630L-N
NOTE
• Before connecting the eClient 630L/630L-N, confirm the following:
- The eClient 630L/630L-N is turned off.
- The WTS is turned on.
• Connect the peripherals to the appropriate connectors of the unit.
2. CONNECTING THE eClient 630L/630L-N 9