User`s manual

9. TROUBLESHOOTING
This page presents problem that can be corre roblem persists even
fter applying the suggested r ntac
cted by the user. If a p
a emedies, co t an EIZO dealer.
Problems Points to check with possible solutions
1. No pi
screen.
eck
 Check nimum settings
will c
 Try p cking
m a power
saving mode.)
cture is displayed on the
 Ch if the power is OFF.
brightness setting. Mi
ause screen to be blank.
ressing a key on the keyboard, or cli
the ouse. (The monitor may be in
2. The f wing messages appear on
screen after the power is on:
(The operation automatically starts
up after the message disappears.)
•
“WARNING
No Keyboard Connected!!”
• “WARNING
No Mouse Connected!!”
 Check if the cable of the keyboard or the mouse
is securely connected.
 Check if the cable of the keyboard or the mouse
is connected to the proper connector.
 Turn off the power, and turn it on a few seconds
later.
ollo
NOTE
When using neither a mouse nor a keyboard
intentionally, it is made to a setup on which an
error is not displayed (See P.38).
3. Input devices (such as a keyboard or
a mouse) do not work properly.
 Check if the cable of the keyboard or the mouse
is securely connected.
 Check if the keyboard or the mouse is
connected to the proper connector.
4. Afterimages appear on the screen.
 Do you use the screen saver when displaying the
same image for extended periods of time?
 Afterimages are particular to LCD monitors.
Avoid displaying the same image for extended
periods of time.
5. The screen has defective pixels (e.g.
slightly light or dark).
 This is due to the characteristics of the panel
itself, and not the failure.
6. Finger prints appear on the screen.
 Leaving the white screen on may solve the
problem.
9. TROUBLESHOOTING 59