User`s manual

15
Chapter2AdjustingScreens
To enhance outline of image
OutlineEnhancer functions to emphasize outline of the images by emphasizing the color difference between
pixels composing the images. This may improve the texture of the material and its feel of the images. On the
contrary, it also functions to reproduce the images smoothly by gradating its outline.
Procedure
1. Choose “Color” from the Adjustment menu, and press
.
2. Choose “Advanced Settings” from “Color”, and press
.
3. Choose “Outline Enhancer, and press
.
4. Select the display status in the range from -3 to 3 (soft to sharp) with
or as desired.
5. Press
to exit.
Reducing motion blur “Blur Reduction
Motion blur occurs when the eye recognizes liquid crystal transitions which comes from changing screens
(frames).
When “Blur Reduction” is set to “On”, the backlight ickers in sync with liquid crystal transition
*1
so the
change cannot be seen, thereby achieving clear images with less blur. (Default setting: On)
*1 This monitor converts 120 Hz input signals into 240 Hz within the panel, and doubles the refresh rate to draw two
images per frame. By applying a voltage higher than the input signal to speed up response (overdrive) for the rst
image, and then drawing the second image with the original input signal, the liquid crystals are stabilized. The
“Blur Reduction” function turns on the backlight only for the stable duration of the second image, and off for other
durations.
Procedure
1. Choose “Color” from the Adjustment menu, and press
.
2. Choose “Advanced Settings” from “Color”, and press
.
3. Choose “Blur Reduction”, and press
.
4. Select “On” or “Off” with
or .
5. Press
to exit.
Attention
Eye fatigue may occur if the eye senses the ickering of the backlight. In such a case, turn the setting to “Off.
The maximum brightness of the screen changes depending on the setting of “Blur Reduction”.
- On: 350 cd/m
2
(typ.)
- Off: 450 cd/m
2
(typ.)
When Color mode is “Paper”, “Blur Reduction” is xed at “Off.