User`s manual

2. How to Adjust the Monitor
31
2-3. Procedure for Measuring Paper White
The target value of a white point and the target brightness can be set by measuring the light that is
reflected from the paper.
1
Select "Paper white" in the new target creation window
2
Select "EPSON Photo Paper" or "Photo Paper" and click [Measure the target...]
3
Initialize the measurement device
The initialization window of the measurement device will open.
When colormunki is connected to the computer, turn the rotary disk to initialization mode.
Click [Initialize]. Initialize the measurement device according to the instructions.
Initialization takes a few seconds. The paper white measurement window will open.
Note
• Be sure that light does not seep through to the sensor of the measurement device during
initialization. Precise adjustment results cannot be obtained if light is detected during the
initialization process.
• When ColorVision Spyder2 or Spyder3 is connected to the computer, this window will not
appear.