User`s manual

30
2. How to Adjust the Monitor
Progress bars are displayed on the right-bottom corner while adjustment is in progress.
Message display area:
Instructions or any software
messages will be displayed
while the adjustment is in
progress.
Progress chart:
The chart shows the status
of adjustment.
Level display chart :
The present adjustment
status is plotted in the
chart.The red cross line
means the target and the
black cross line indicates
the present status.
Brightness bar:
The present brightness level
is shown in the brightness
bar. The target brightness
level is marked in red.
11
Confirm the result
After completing the monitor adjustment, confirm the result in the displayed result window.
Store the adjustment
result and generate a
monitor profile.
About monitor validation,
refer to "3-1. Monitor
Validation".
* Depending on the setting
[Validation Result...]. is
displayed.
Note
• If the black level became to minus value and the adjustment failed, an error message is displayed.
Follow the indication displayed in the window and adjust the monitor from the beginning again.
The measurement device may not have been attached to the monitor closely or light may have
seeped through to the sensor of the measurement device during initialization.