User`s manual

2. How to Adjust the Monitor

2-2. Monitor Adjustment Procedure (Creating a New

Target)

Create a Target to Adjust the Monitor

It is possible to set the adjustment target by specifying each value of brightness, white point and gamma.

Flow Diagram

Note

• When you perform the monitor adjustment, the monitor automatically switches to CAL mode/

EMU mode (i.e. Calibration mode/Emulation mode). The monitor adjustment result is only

registered in CAL mode/EMU mode. (The result is not registered in other modes.)

• When you adjust 6 colors on CG18, CG19, CG21 monitors, the monitor adjustment result is

registered to the Custom mode.

Start up ColorNavigator

Select the measurement device

* The software adjusts the monitor automatically.

Adjust the monitor

・Gamma

・Brightness

・Gain

・Gamut

＊1

・Black Level

＊2

* Show after the monitor adjusting is complete.

*1: Gamut is available on CG220/CG221/CG222W/CG241W/CG301W

*2: Black level is available for digital input in CE series.

初期画面表示

Adjust the monitor

periodically

* The message shows in multiple monitor

environment.

モニター選択

Set the target details

Measure the target

* Some measurement devices can set the

target by measuring ambient light or

paper white.

* It is possible to set each target for brightness,

white point, gamma and black level.

Show the startup window

Select a monitor

Create a new target

Initialize the measurement device

Show the result

Generate the Profile

Quit ColorNavigator

* Save the monitor adjustment result and generate the profile.