User`s manual

18
2. How to Adjust the Monitor
7
Confirm the result
When the monitor adjustment has been finished, the result window will appear. Confirm the
result.
Store the adjustment
result and generate a
monitor profile.
About monitor validation,
refer to "3-1.Monitor
Validation".
Note
•If the black level became to minus value and the adjustment failed, an error message is displayed.
Follow the indication displayed in the window and adjust the monitor from the beginning again.
It's because the measurement device could not have been attached to the monitor closely or light
could have seeped through to the sensor of the measurement device during initialization.
8
Save a profile
Click [Save] and then the message "The adjustment of the monitor is completed." is displayed.
Click [Quit]. (Mac OS)
Click [Exit]. (Windows)
The monitor adjustment is finished.
Note
• The suitable modes for the display image are available on the monitor (fine contrast mode).
When you perform the monitor adjustment with ColorNavigator, the monitor automatically
switches to CAL mode/EMU mode (i.e. Calibration mode/Emulation mode). The monitor
adjustment result is only registered in CAL mode. (The result is not registered in other modes.)
• Once the monitor is adjusted by ColorNavigator, avoid adjusting the monitor image to no
purpose. If the monitor image is adjusted after monitor adjustment, the adjustment result will
be lost.
• Do not select the color profile on your OS after the profile is saved, or color management cannot
be conducted properly.