User`s manual

2. How to Adjust the Monitor

This section describes adjustment procedures when one monitor is connected to computer. To adjust

several monitors in a multiple monitor environment, refer to "4. Using ColorNavigator in Multiple

Monitor Environment".

2-1. Monitor Adjustment Procedure (Selecting a Target)

Select an Adjustment Target from the List to Adjust the Monitor

Flow Diagram

Note

• The suitable modes for the display image are available on the monitor (ﬁne contrast mode).

When you perform the monitor adjustment with ColorNavigator, the monitor automatically switches

to CAL mode/EMU mode (i.e. Calibration mode/Emulation mode). The monitor adjustment result is

only registered in CAL mode. (The result is not registered in other modes.)

Generate the Profile

Show the result

* Select a target from the list.

* The software adjusts the monitor automatically.

* Save the monitor adjustment result and generate the profile.

* Show after the monitor adjustment is complete.

Select targets

for Printing

for Photo & Design

Start up ColorNavigator

Select the measurement device

* The message shows with multiple monitor

environment.

Show the startup window

Select a monitor

Initialize the measurement device

Adjust the monitor

・Gamma

・Brightness

・Gain

・Gamut

＊1

・Black Level

＊2

Quit ColorNavigator

*1: Gamut is available for CG220/CG221/CG222W/CG241W/CG301W

*2: Black level is available for digital input in CE series.

Adjust the monitor

periodically