User Manual

Chapter 4 SelfCalibration

This product is equipped with a built-in calibration sensor. By setting the calibration targets and execution

schedule in advance, the calibration sensor automatically operates and regularly calibrates the monitor.

This automatic calibration function is called “SelfCalibration”.

The adjustment content of SelfCalibration differs depending on the color mode that is executed.

• Calibration Mode (CAL mode: CAL1 / CAL2 / CAL3):

- When performing SelfCalibration on the monitor itself, calibrate the monitor to match the set targets.

- When using ColorNavigator 6, use ColorNavigator 6 and a measurement device to maintain the

calibrated state of the monitor.

• Standard Mode (color mode excluding CAL1 / CAL2 / CAL3): the monitor's color reproduction gamut is

updated and each display mode in Standard Mode is adjusted as follows:

- The temperature is adjusted so that it is as close as possible to the specied value.

- The gamut values are adjusted so that they are close to each specied value.

- Information on brightness is updated.

You can set the calibration targets and execution schedule in the monitor's Adjustment menu or in

ColorNavigator 6.

In this section, the settings for executing SelfCalibration on the monitor as a standalone unit are explained.

For the settings in ColorNavigator 6, refer to the ColorNavigator 6 User's Manual (stored on the CD-ROM).

Note

• The measurement results from the built-in calibration sensor can be correlated with the measurement results from

the measurement device you use. For details, refer to the ColorNavigator 6 User's Manual (stored on the CD-ROM).

• When the main power of the monitor is on, SelfCalibration can also be performed when there are no PC signals

being input.

4-1. Setting the Color Mode for Executing SelfCalibration

●

CAL mode

The Cal Mode setting is performed in “Color” of the Adjustment menu.

Note

• Multiple CAL modes can be enabled for one input signal. For more information, see “3-2. Skipping Unused

Display Modes” (page 31).

Procedure

1. Switch to desired color mode.

2. Choose “Color” from the Adjustment menu, and press

3. Choose “Target” from “Color”, and press

The target setting window appears.

4. Choose “SelfCalibration” from the “Target” menu, and press .

5. Select “On” or “Off” with

or , and press .

6. Press

to exit.