Installation Guide

STEP 4
STEP 5
Connect the flexible hoses to the bottom of the faucet body. if the water feed tubes are already connected to your
faucet, move on to step 5. These are meant to be hand tightened only. Once the hoses begin to warp as you turn
them they have been tightened enough, any further tightening could damage the connection tubes.
TIP: Each hose is marked with a sticker, blue for cold and red for hot water. After the hoses have been connected
place a piece of masking tape on the red, or hot water hose to help ensure that the two do not get crossed at any
time during installation.
Thread the water feed tubes through the hole on the floor and connect to the main water supply via the
under-floor access space. Briefly turn on the water supply to make sure there are no leaks in the water feed tubes
before you fix the faucet to the fllor. If no leaks are detected, turn o the water supply and continue with the
installation. If leakage does occur, use your adjustable wrench to tighten the connections as necessary. If
Problem persist, contact customer service at 213-425-3095.
OR