Instructions
Table Of Contents
- Einfügen aus: "FM074342_04_de.pdf"
- 1 Allgemeine Angaben
- 1.1 Hersteller Metallwarenfabrik Gemmingen
- 1.2 Angaben zur Betriebsanleitung
- 2 Erläuterung der Symbole
- 2.1 Symbole in der Betriebsanleitung
- 2.2 Warnhinweise
- 2.3 Symbole am Gerät
- 3 Sicherheitshinweise
- 3.1 Aufbewahrung der Betriebsanleitung
- 3.2 Sichere Verwendung
- 3.3 Bestimmungsgemäße Verwendung
- 3.4 Umbauten und Änderungen
- 4 Funktion und Geräteaufbau
- 4.1 Funktion
- 4.2 Geräteaufbau
- 5 Technische Daten
- 6 Transport und Lagerung
- 6.1 Allgemeines
- 6.2 Batterien
- 7 Montage und Installation
- 7.1 Maßangaben / Befestigungsmaße
- 7.2 Montage / Demontage, Gebrauchslage
- 7.2.1 Montage Ladesessel
- 7.2.2 Montage Adapter in Fremdgeräteladesessel
- 7.2.3 Montage Gürtelhaken
- 8 Inbetriebnahme
- 9 Betrieb
- 9.1 Normalbetrieb
- 9.1.1 Funktion
- 9.1.2 Einschalten / Wechsel der Funktion
- 9.1.3 Ausschalten
- 9.1.4 Dimm-Modus
- 9.2 Notlichtbetrieb
- 9.2.1 Ein- und Ausschalten des Notlichtbetriebs
- 9.3 Ladebetrieb
- 9.3.1 Laden der Batterie
- 9.3.2 Ladeabschaltung bei Verwendung im KFZ
- 9.4 Test der Batteriekapazität
- 9.5 Anzeigen
- 9.6 Fehlerbeseitigung
- 9.6.1 Fehler LED-Spannung
- 10 Instandhaltung, Wartung, Reparatur
- 10.1 Instandhaltung und Wartung
- 10.1.1 Austausch Batterie
- 10.1.2 Reinigung
- 10.2 Reparatur
- 10.3 Rücksendung
- 11 Entsorgung
- 12 Zubehör und Ersatzteile
- 13 EG-Konformitätserklärung
- Einfügen aus: "FM074342_04_en.pdf"
- 1 General Information
- 1.1 Hersteller Metallwarenfabrik Gemmingen
- 1.2 Information regarding the operating instructions
- 2 Explanation of the symbols
- 2.1 Symbols in these operating instructions
- 2.2 Warning notes
- 2.3 Symbols on the device
- 3 Safety notes
- 3.1 Operating instructions storage
- 3.2 Safe use
- 3.3 Intended Use
- 3.4 Modifications and alterations
- 4 Function and device design
- 4.1 Function
- 4.2 Device design
- 5 Technical data
- 6 Transport and storage
- 6.1 General
- 6.2 Batteries
- 7 Mounting and installation
- 7.1 Dimensions / fastening dimensions
- 7.2 Mounting / dismounting, operating position
- 7.2.1 Charging Unit Assembly
- 7.2.2 Assembly of the adapter in third-party charging units
- 7.2.3 Assembly of the belt hook
- 8 Commissioning
- 9 Operation
- 9.1 Normal Operation
- 9.1.1 Function
- 9.1.2 Switching On / Changing the Function
- 9.1.3 Switching off
- 9.1.4 Dimming mode
- 9.2 Emergency light operation
- 9.2.1 Switching the emergency light mode on and off
- 9.3 Charging Operation
- 9.3.1 Battery charging
- 9.3.2 Charging switch-off when used in a motor vehicle.
- 9.4 Battery capacity test
- 9.5 Indications
- 9.6 Troubleshooting
- 9.6.1 LED voltage errors
- 10 Maintenance and repair
- 10.1 Maintenance
- 10.1.1 Battery replacement
- 10.1.2 Cleaning
- 10.2 Repair
- 10.3 Returning the device
- 11 Disposal
- 12 Accessories and Spare parts
- 13 EC Declaration of Conformity
FM074342
2015-10-09·BA00·III·en·04
Operation
13
Portable Lamp
HSE 7 LED / LS 7 LED
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
9 Operation
9.1 Normal Operation
The portable lamp is mobile lighting equipment.
9.1.1 Function
• Main light - Switching on / Dimming / Switching off
• Main light - Flashing (flashing frequency once per second)
• Secondary light - Switching on / Switching off
9.1.2 Switching On / Changing the Function
Switching on:
Press the pushbutton
• The main light is switched on.
Switching
Press pushbutton repeatedly while the LED display is active.
• The secondary light is switched on.
• The main light flashes once per second.
• The LED is switched off.
9.1.3 Switching off
Press the pushbutton:
• if the main light is flashing.
• 5 seconds after the last switching operation.
DANGER
Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation and function before commis-
sioning.
• Comply with the national regulations.
CAUTION
Risk of damage to the eyes caused by optical radiation!
Minor injuries are possible!
• Do not look into the light source.
The main or secondary light of the portable lamp can only be switched on if
the portable lamp is outside the charging unit.
The undimmed main light and the secondary light light flicker-free.
The main light is switched automatically to the secondary light when:
• the main light is defective.
• the battery capacity is less than 10%.
The LED display shows the battery capacity for 5 seconds.