User guide

2
Recommendations and
safety instructions
For safety reasons, never put the handset in the base station without the
battery inserted or without the lid on the battery compartment as this
could cause an electric shock.
To avoid damaging your handset/base, only use certified rechargeable
batteries NiMH 1.2 V 650 mAh, never use no rechargeable batteries.
Insert the batteries in the handset/base battery compartment respecting
polarity.
Only use the power unit supplied and connect it to the electricity mains in
accordance with the installation instructions in this user manual and the
details on the sticker regarding voltage, electrical current and frequency.
As a precaution if there is a risk of danger, the power plug can be pulled
out to disconnect the 230 volt power supply. Therefore the sockets should
be near the device and easily accessible.
Do not install your DECT telephone in a damp environment, such as a
bathroom, washroom, kitchen etc, and not within 1.50 metres of a source
of water or outside. This device is designed for use in temperatures of
between 5 °C and 45 °C.
In regions greatly affected by electrical storms we recommend that you
protect your telephone circuit with a special fixture for excess voltage.
Do not attempt to remove screws or open the appliance. It does not
contain any user-replaceable parts.
This device is designed to be used for connecting to the public telephone
network. If problems should arise, contact your nearest specialist dealer.
Only use the telephone cable supplied.
Your DECT telephone has a range of approx. 50 metres indoors and up
to 300 metres outdoors. The range can be affected by the proximity of
metal objects, such as a television and electrical devices.
Zones without reception may appear owing to elements in the building.
This can cause brief interruptions in the conversation, caused by faulty
transmission.
!