User guide

36
SETTINGS
To exit the menu, press the red key .
Modifying the dialling mode
Depending on the type of network your
telephone is linked to, it uses tone or pulse
dialling.
This function enables you to configure your
telephone according to the type of dialling
used by your network.
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET LINE using  or . Press
Valid. .
Select DIAL using  or . Press
Valid. .
A screen displays the current status (pulse
or tone).
• To keep the status, press Valid. .
• To change the status, press Edit .
The status is modified on the screen,
press Valid. .
To exit the menu, press the red key .
Modifying the flash duration
(R key)
If you connect your telephone to a private
automatic branch exchange or use it in a
foreign country, you may need to modify the
flash duration in order to use your telephone
correctly with regard to the following
functionalities: outgoing 2nd call, incoming
2nd call, 3 way calling.
Contact your service provider to obtain the
correct flash duration and then modify it by
doing the following.
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET LINE using  or . Press
Valid. .
Select FLASHING using  or . Press
Valid. .
An information screen presents the current
flash duration.
• To keep the duration, press
Confirm .
• To modify the duration, press Edit .
Select the new duration using  or . Press
Valid. .
The screen presents the new flash duration.
• To keep the duration, press
Confirm .
LU Eircom 8010R_D66.book Page 36 Vendredi, 28. novembre 2008 10:05 10