User guide

33
SETTINGS
Enter the base code. Press Valid. .
The handset enters the registration mode,
"HANDSET IN REGISTR. MODE" is
displayed on the screen.
Put the base to which you want to register the
handset in registration mode.
Once the handset is registered, select the
required handset number. Press
Valid. .
On the base:
Put the base to which you want to link the
handset in registration mode and press the
base button for several seconds.
The base is in registration mode.
The new handset and the base are mutually
searching for each other. The registration
may take several seconds.
Once the handset is registered, the handset
automatically exits the registration mode and
lets you know the registration is done.
You can also set your base to the
registration mode using a handset
already registered by selecting the
Registration function in the menu
SETTINGS/ADVENCED SET./SET
BASE.
ADVANCED SETTINGS /
BASE SETTINGS
Using a handset to put the base
in registration mode
This function enables you to put the base in
registration mode so you can register a new
handset. To do so, the handset to be
registered must be in registration mode (refer
to paragraph Registering a new handset to
a base, page 31).
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET BASE using  or . Press
Valid. .
Select REGISTR. MODE using  or .
Press Valid. .
A screen prompts you to confirm the setting
of the base to the registration mode. Press
Yes to enter the registration mode. The
indicator light on your base starts to quickly
blink green.
Your base will remain in registration mode for
about 1 minute.
You can also put the base in
registration mode by pressing the
base button (long press).
LU Eircom 8010R_D66.book Page 33 Vendredi, 28. novembre 2008 10:05 10