User guide

27
SECURITY
Modifying the base code
The base code (0000 being the default
setting) is required to access certain security
functions. It must be composed of 4 digits.
On the navigator key , press  or 
until the SECURITY screen is displayed,
press OK to confirm.
Select CHANGE CODE using  or . Press
Valid. .
Enter the old base code using the keypad
(default is 0000). Press Valid. .
Enter the new base code using the keypad.
Press Valid. .
Confirm by entering the new base code
again. Press Valid. .
To exit the menu, press the red key .
Carefully note down the base code
number. You will need this code to
change certain settings.
Authorising listening in
The intrusion function authorises or prevents
a second handset registered on the same
base from joining in a current conversation. If
the intrusion mode is active, it is then
possible to join a conversation in progress
using another handset.
On the navigator key , press  or 
until the SECURITY screen is displayed,
press OK to confirm.
Select INTRUSION using  or . Press
Valid. .
A screen displays the current status (on
or off).
• To change the status, press Edit .
• To keep the status, press Valid. .
To exit the menu, press the red key .
LU Eircom 8010R_D66.book Page 27 Vendredi, 28. novembre 2008 10:05 10