Manual

IF YOUR DEHUMIDIFIER FAILS TO
OPERATE
1.
Check that the plug is fully pushed into the
socket and is switched on.
2.
Check with some other electrical device that
the wa
ll socket is “live”. If it is not, contact a
qualified electrician.
3.
Check the fuse in the plug. If you replace the
fuse, refit with a 13Amp fuse.
4.
Check the humidistat control is turned
clockwise.
5. Check that the water container is not full.
Should none of t
he above remedies work, then
disconnect from the mains. Contact the help line on
01388 664400
. DO NOT attempt to repair the unit
or unscrew the outer casing.
If the appliance is fitted with a plug for
which your
socket is unsuitable, then it should be cut off and
an appropriate plug fitted..
As the colours of the wires in the mains lead of this
appliance may not c
orrespond with the coloured
markings identifying the terminals in your own plug,
proceed as follows:
The wire which is coloured Green and Yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the Earth Symbol or
colou
red Green and Yellow. The wire which is
coloured Blue must be connected to the terminal in
the plug which is marked with the letter N or
coloured Black. The wire which is coloured Brown
must be connected to the terminal which is marked
with the letter L or coloured Red.
You must dispose of the non rewireable plug once it
has been removed from the flexible cord. It is
dangerous to attempt to insert the plug into any
electrical socket elsewhere in the house. If the
flexible cord becomes damaged it must be r
eplaced
by an identical cord.
CHANGING THE FUSE
Only 13 Amp fuses that are ASTA approved to
BS1362 should be used.
The fuse cover must be refitted after replacement
of the fuse. In the event of the fuse cove
r being lost
or damaged, the plug must not be used until a
replacement is obtained. Replacement fuse covers,
which must be coloured BLACK, are obtainable
from electrical retailers.
This appliance complies with the suppression
requirements of the EEC direction 82/199/EEC as
embodied in BS800:1988.
IMPORTANT:- The wires in this mains lead are
coloured in accordance with the following code:-
Green & Yellow Earth
Blue Neutral
Brown Live
AIR FILTER REMOVAL AND CLEANING
The WM20 has a filter to remove dist from
the air and
also protect the unit. This requires
cleaning and we recommend that the filter is
inspected and cleaned every 4 weeks.
Failure to do so will reduce the efficiency of
your WM20.
To access the filter the cover of the unit must
first be removed.
!! DISCONNECT THE POWER LEAD ROM
THE WALL SOCKET BEFORE
COMMENCING !!
Remove all the screws around the outside
edges of the cover, carefully withdraw the
cover and disconnect the cable attached to
the control panel.
Remove the filter from the filter holder located
on the inside of the cover.
Clean using a vacuum cleaner on a low
power setting, or replace the filter material.
Refit in reverse order
USER
MAINTENANCE
ELECTRICAL
CONNECTIONS