Manual

Your EIP Dehumidifier is packed
in a plastic wrapper –
please
ensure that it is disposed of safely
and where it will not be a danger
to children
INTRODUCTION
Your EIP WM20 Dehumidifier is
designed to help dry flooded or da
mp
areas. Ideal where natural drying is just
too slow. Drying with a dehumidifier
enables fast drying without problems
assosiated with heat drying plaster, etc
can crack.
HOW YOUR DEHUMIDIFIER WORKS
Your dehumidifier draws in the moist air,
cooling it to a temperature where excess
moisture will condense, thereby
removing the excess moisture. T
his in
turn dries anything in the immediate area
which is damp. The moisture is collected
in the water container. The air is
rewarmed and passed back
approximately 2°C warmer.
IMPORTANT
CHOOSE YOUR LOCATION
.
The WM20 draws the air in, through th
e
air
filter fitted to the front cover, and
discahrges the dry air through the outlet
grilles on either end of the unit.
Inorder
to clean
the airfilter the cover must be
first removed.
The ideal location should meet the
minimum dimensions shown on the the
drawing
Recommended Minimum
Distances
. Maintaining these dimensions
will ensure the dehumidifier airflow is un
restricted, therby keeping the units
optimum performance, and also ensure
the unit is easy to operate and maintain.
The WM20 is supplied complete
with a
wall mounting bracket and suitable wall
plugs and screws.
INSTALLATION
•
Drill the wall for the top 2 mounting
holes in accordance with the drawing
Mounting Hole Centers.
•
Fit the wall plugs and screws to these
2 holes, leaving the screws partiall
y
loose by approximately 15mm
•
Lift and clip the dehumidifier onto
these 2 screws.
•
Check to ensure the unit is level
before fully tightening
(failure to
ensure the unit is level
may result
in the unit flooding).
• Mark the
wall, through the bottom
mounting h
oles in the dehumidifier,
inorder to obtain an accurate position.
•