Manual

WM150 OWNERS MANUAL Page 3 of 16
Drawing No.
:
-
TPC551
Issue :- 1
Date :- 19/05/21
INTRODUCTION
Designed for a wide range of applications, the WM150 is a rugged, industrial unit,
which utilizes an energy-efficient compressor and a compact portable design to
provide easy efficient drying.
The WM150 has a number of special features:
• High efficiency rotary compressor
• Ebac’s “Reverse Cycle” defrost system
• Integral pump out system
• Provision for permanent drainage
• Exterior epoxy powder-coated finish
• Extra long power cord
• Free Standing or Wall Mountable
• Status Indicators
• Control Humidistat
The fan draws the moist air through the cold evaporator coil, which cools the air below
its dew point. Moisture forms on the evaporator coil and is collected in the condensate
tray, which is equipped with a permanent drain. The cooled air then passes through
the hot condenser coil where it is reheated using the same energy removed during the
cooling phase, plus the additional heat generated by the compressor. The air is,
therefore, discharged from the dehumidifier at a slightly higher temperature with a
lower absolute humidity than that which entered. Continuous circulation of air through
the dehumidifier gradually reduces the relative humidity within the area.
The WM150 dehumidifier is a reliable drying unit designed to operate effectively over
a broad range of temperature and humidity conditions. An active hot gas defrost
system, controlled by an electronic timer, guarantees positive de-icing, thereby
optimizing operation at low temperatures.