Drawing No.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 WM150 PACKAGE CONTENTS Item Description Quantity 11285GL-US Dehumidifier 1 3082214 Brass wood screws 4 3088525 Rawl plug 4 3086144 Quick release hose coupling 1 3944110 PVC tube – 3/8” I/D 7.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 INTRODUCTION Designed for a wide range of applications, the WM150 is a rugged, industrial unit, which utilizes an energy-efficient compressor and a compact portable design to provide easy efficient drying.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 SPECIFICATIONS MODEL: 11285GL-US HEIGHT: 26.7” (680 mm) WIDTH: 31.8” (810mm) DEPTH: 12” (305mm) WEIGHT: 81.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 OPERATION The following procedures should be followed to test the WM150 for correct operation: 1. After unpacking, examine all external features to confirm damage-free shipment. Report all defects and damage at once. Connect the power cable to a grounded 13 Amp electrical socket. Connect the drainage outlet to a suitably sized hose and run the hose to a permanent drain. CAUTION DO NOT REMOVE COVERS WHEN THE UNIT IS IN OPERATION 2.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 Light Functions: The unit has four LED indicators, located on the side of the unit.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 INSTALATION The WM150 Dehumidifier can be left free standing unit, alternatively can be wall mounted for instructions on mounting the unit please read the following: A full installation kit is included in the package to allow a problem free install.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 ROUTINE SERVICE WARNING ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE SERVICE. THE SERVICING AND REPAIR OF THIS UNIT SHOULD ONLY BE CARRIED OUT BY A SUITABLY QUALIFIED PERSON. To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: 1. Clean the surface of the evaporator and condenser coils by blowing the dirt out from behind the fins with compressed air.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 REPAIRS 1. Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. 2. If refrigerant gas is lost from the machine, it will be necessary to use a Refrigeration technician to correct the fault. Contact the Factory Service Center prior to initiating this action. Any competent refrigeration technician will be able to service the equipment. The following procedure must be used: a.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 TROUBLESHOOTING SYMPTOM CAUSE Unit inoperative 1. No power to unit 1. 2. 3. 4. Little or no airflow Loose fan on shaft Fan motor burnt out Dirty refrigeration coils Loose electrical wiring 1. Insufficient air flow 2. Compressor fault 3. Loss of refrigerant gas Little or no water extraction Little or no defrost when required 1. Faulty timer 2. Faulty by-pass valve 1. Loose compressor Unit vibrates excessively 2.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 WM150 SPARE PARTS LIST Description Product Part Number PCB Timer Controls Display Timer Humidity Sensor PCB PCB Connecting Cable Condenser Coil Evaporator Coil Filter Keypad Label Capillary Tube Insulation Tube 10mm ID Silicone Drain Tray Tube Solenoid Valve Filter Dryer Solenoid Coil Mains Cable 20mm Open Grommet M16 Gland Nut Humidity Sensor Housing M16 Gland Rocker Switch Capacitor Fan Motor Spire Clip No.
Drawing No.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 WARNINGS This appliance can be used by children from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the application in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 LIMITED WARRANTY Our products carry a one-year unconditional warranty against any defects in workmanship or material. This warranty will cover all parts and labor required to repair your Ebac product. This warranty is invalid if the unit has been abused, damaged, whether intentional or accidental, or if any modifications have been made to the unit.
Drawing No.
Drawing No. :- TPC551 Issue :- 1 Date :- 19/05/21 UK Head Office American Sales Office Ebac Industrial Products Ltd St Helens Trading Estate Bishop Auckland County Durham DL14 9AD Ebac Industrial Products Inc 700 Thimble Shoals Blvd. Suite 109, Newport News Virginia, 23606-2575 USA Tel: +44 (0) 1388 664400 Fax: +44 (0) 1388 662590 Tel: +01 757 873 6800 Fax: +01 757 873 3632 www.eipl.co.uk sales@eipl.co.uk www.ebacusa.com sales@ebacusa.
