Brochure

SPECIFICATION

Height: 33” (820mm)

Width: 43” (1070mm)

Depth: 12” (290mm)

Weight: 167lbs (76kg)

Airflow: 600CFM (1028m³/hr)

Power Rating (dryer) 1100W

Power Rating (heater) 1500W (Operates Intermittently)

Power Requirements: 220V/60Hz/1ph -12 amps

Maximum Operating Temperature: 122˚F (50˚C)

Control: STC1 Controller (Supplied)

Finish: Epoxy / Vinyl

Special Features: Stainless steel water collection tray for corrosion resistance.

Drying chamber temperature indicator.

Wall mounted to save space inside the drying chamber.

LD3000 WOOD DRYER

OPTIMUM CAPACITY

The EIPL LD3000 has been designed to dry the following maximum wood loads:

1” Hardwoods

3,000BF (250 cu ft)

2” Hardwoods

5,150BF (430 cu ft)

3” Hardwoods

8,875BF (740 cu ft)

1” Softwoods

1,440BF (120 cu ft)

2” Softwoods

3,240BF (270 cu ft)

3” Softwoods

5,400BF (450 cu ft)

EIPL will be pleased to discuss your precise drying needs on a case-by-case basis.

PACKAGED SYSTEMS

The LD3000 with the STC1 Controller and two supplementary fans are all you need to start drying wood.

The STC1 controller consists of a proportional timer to control the drying cycle and a thermostat to control

the heating cycle. Extra equipment such as venting units and supplementary heaters are normally not

required. The drying speed is controlled at a rate which will not cause degrade, therefore humidification

equipment is unnecessary.

PRECISION DRYING THROUGH DEHUMIDIFICATION

SPECIFICATIONS

PAGE 1
SPECIFICATION Height: Width: Depth: Weight: Airflow: Power Rating (dryer) Power Rating (heater) Power Requirements: Maximum Operating Temperature: Control: Finish: Special Features: 33” (820mm) 43” (1070mm) 12” (290mm) 167lbs (76kg) 600CFM (1028m³/hr) 1100W 1500W (Operates Intermittently) 220V/60Hz/1ph -12 amps 122˚F (50˚C) STC1 Controller (Supplied) Epoxy / Vinyl Stainless steel water collection tray for corrosion resistance. Drying chamber temperature indicator.
PAGE 2
THE LD3000 WOOD DRYER The LD3000 is a packaged drying system for the wood retailer or other craftsman who require quality kiln dried wood. The unit is complete and ready for installation into a home built drying chamber. The LD3000 has been designed to operate effectively at low humidity levels therefore you can be certain that your wood is thoroughly dried to the moisture content you need, as low as 6%. SAVE MONEY Typically, green lumber costs less than half the price of kiln dried supplies.