Brochure

SPECIFICATIONS 10501SS-US
Height 14.5” (370 mm)
Width 14.2” (360 mm)
Depth 17” (430 mm)
Weight 44 lbs (20 kg)
Voltage 110 V
Current 12.4 A
Phase 1
Frequency 60 Hz
Power 1.4 kW
Process Airflow – Dry Air 136 cfm (231 m3/hr)
Regen Airflow – Wet Air 42 cfm (71 m3/hr)
Process Duct Size – Dry Air 5” (130 mm)
Regen Duct Size – Wet Air 2.75” (70 mm)
Rotor Wheel Speed (rph) 20
Noise Level 67 dba
Typical Extraction @ 27°C 60% 69 ppd (32.6 lt/day)
Min Operating Temperature -4 °F (-20°C)
Max Operating Temperature 104 °F (40°C)
FEATURES 10501SS-US
On/Off Control

Ammeter

Electronic Controls

Manual / Automatic Mode
Selection

Remote Humidity Sensor Facility

Hours Run Meter

Fitted Mains Plug

Fan Speeds 1
High Capacity PTC Heater

Process / Regen Air Filter

Rubber Anti-Vibration Feet

Single, Air Inlet Design

Free Standing

Humidistat O
Carrying Handles

Stainless Steel Construction

Inlet Duct Attachments O
High Temperature Safety Cut-outs

DD300 DESICCANT DEHUMIDIFIER
APPLICATION
Dehumidifiers are required wherever there is a need to lower the humidity level to prevent corrosion,
mold growth and condensation or maintain a low humidity condition during manufacture, packaging
or storing of hygroscopic products.
METHODS OF DEHUMIDIFICATION
Dehumidification is possible using two possible principles, Condensation with refrigeration style
dehumidifiers and Adsorption with desiccant dehumidifiers.
Desiccant dehumidifiers perform exceptionally well when used in cooler climates, or when a low
dew-point, deep drying or low humidity levels are required. Since desiccant dehumidifiers do not
produce water, they will work effectively down to sub zero temperatures.
Their operation is simplistic yet extremely effective and reliable.
Air (Process Air) is drawn into the dehumidifier, where is passes over a wheel impregnated with
Silica Gel. As the air passes over this wheel, any moisture present in the air is absorbed into the
Silica Gel wheel before leaving the dehumidifier as warm dry air.
The Silica Gel wheel is continually, slowly rotating,
typically at three revolutions per hour. As the
wheel rotates, a small portion passes through the
regeneration segment. During this phase a second
air stream (Regeneration Air) is heated to a high
temperature before passing over the wheel. Any
moisture present in the wheel is released into this
air stream; this hot wet air is then exhausted
outside the area being dried.
KEY DESIGN FEATURES
• Stainless Steel Construction
• Auto / Manual Mode Selection
• Electronic Controls
• High Capacity PTC Heater
• Remote Humidistat Facility
• Low Temperature Operation
• Ammeter
PHARMACEUTICAL, CONFECTIONARY, DEFENSE INDUSTRY,
WATER DAMAGE, COLD STORES, POWER STATIONS, PLASTICS
SPECIFICATIONS