Manual

Page 9 of 15
Drawing : - TPC 356
Issue : - 9
Date : - 02/05/19
ROUTINE SERVICE & REPAIR
To ensure continued full efficiency of the dehumidifier, maintenance
procedures should be performed as follows:
• We recommend that the filter is checked at least once a month.
Intervals for cleaning or replacement of filters will depend on the
installation
• Never operate the dehumidifier without the filters as the rotor can be
damaged by dust.
To carryout the following, it is necessary to remove the top cover panel.
This machine should be serviced by qualified Ebac Industrial Products Ltd
personnel or other persons having technical competence in servicing
electrical equipment following the instructions in this Service Manual.
• The rotor is maintenance free. However, should it be necessary to
clean the rotor, compressed air should be used to carefully blow dirt
from the rotor.
• The PTC heaters are maintenance free. However should it be
necessary to clean the heaters, compressed air should be used to
carefully blow dirt from the heaters.
• Check that the fan is firmly secured and that the fan rotates freely.
• Check all wiring connections.
• Check the belt tensioning at regular intervals. Adjust when needed by
loosening the four bolts holding the drive wheel and rotating the drive
motor until correct tension is achieved.
• The overheat protector is located inside the unit, towards the front,
near the rotor. To reset this device press the red button.
• Should an electrical component fail, consult the Factory Service Center
to obtain the proper replacement part.
WARNING:
ENSURE THAT THE POWER CORD TO THE MACHINE HAS
BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE
SERVICE. THE SERVICING AND REPAIR OF THIS UNIT
SHOULD ONLY BE CARRIED OUT BY A SUITABLY QUALIFIED
PERSON.
SWITCH OFF THE DEHUMIDIFIER APPROXIMATELY 15
MINUTES PRIOR TO REMOVING ANY PANELS, ALLOWING
THE HEATER TO COOL DOWN