Brochure

SPECIFICATIONS 10540GR-US 10541GR-US
Height (inch) 56 56
Width (inch) 28 28
Depth (inch) 23 23
Weight (lbs) 200 200
Voltage (V) 220 460
Current (A) 31 15
Phase 3 3
Frequency (Hz) 60 60
Power (kW) 11.8 11.8
Process Airflow Maximum – Dry Air (cfm) 883 883
Process Airflow Nominal – Dry Air (cfm) 705 705
Regen Airflow Nominal – Wet Air (cfm) 195 195
Process Air Outlet Dia (inch) 8 8
Regen Air Outlet Dia (inch) 6 6
Rotor Wheel Speed (rph) 13.6 13.6
Rotor Size dia X depth (inch) 13.8 X 7.9 13.8 X 7.9
High Extraction Setting @ 27°C 60% (ppd) 562 562
High Efficiency Setting @ 27°C 60% (ppd) 402 402
Deep Drying Settings @ 27°C 60% (ppd) 508 508
Typical Dry Air Off – High Extraction Setting (%) 9 9
Typical Dry Air Off – High Efficiency Setting (%) 12 12
Typical Dry Air Off – Deep Drying Settings (%) 5 5
Min Operating Temperature (°F) -4 -4
Max Operating Temperature (°F) 104 104
FEATURES DD1200
On/Off Control
4
Adjustable Thermostat
4
Electronic Controls
4
Manual / Automatic Mode Selection
4
Remote Humidity Sensor Facility
4
Hours Run Meter
4
EC High Efficency Fans
4
Variable Fan Speeds
4
High Capacity PTC Heaters
4
Process / Regen Air Filter
4
Rubber Anti-Vibration Feet
4
Dual Air Inlet Design
4
Free Standing
4
Status Indicators
4
Self Contained
4
Stainless Steel Construction O
Inlet Duct Attachments O
High Temperature Safety Cut-outs
4
DD1200 DESICCANT DEHUMIDIFIER
PHARMACEUTICAL, CONFECTIONARY, DEFENSE INDUSTRY,
WATER DAMAGE, COLD STORES, POWER STATIONS, PLASTICS
SPECIFICATIONS
APPLICATION
Dehumidifiers are required wherever there is a need to lower the humidity level to prevent corrosion, mold
growth and condensation or maintain a low humidity condition during manufacture, packaging or storing of
hygroscopic products.
METHODS OF DEHUMIDIFICATION
Dehumidification is possible using two possible principles, Condensation with refrigeration style
dehumidifiers and Adsorption with desiccant dehumidifiers. Desiccant dehumidifiers perform exceptionally
well when used in cooler climates, or when a low dew-point, deep drying or low humidity levels are
required. Since desiccant dehumidifiers do not produce water, they will work effectively down to sub zero
temperatures.
Their operation is simplistic yet extremely effective and
reliable. Air (Process Air) is drawn into the dehumidifier,
where is passes over a wheel impregnated with Silica
Gel. As the air passes over this wheel, any moisture
present in the air is absorbed into the Silica Gel wheel
before leaving the dehumidifier as warm dry air.
The Silica Gel wheel is continually, slowly rotating,
typically at three revolutions per hour. As the wheel
rotates, a small portion passes through the regeneration
segment. During this phase a second air stream
(Regeneration Air) is heated to a high temperature
before passing over the wheel. Any moisture present in
the wheel is released into this
air stream; this hot wet air is then exhausted outside the
area being dried.
KEY DESIGN FEATURES
• EC High Efficency Forward Curve Fans
• Infinitely Variable Fan Speed