Manual

SPECIAL FEATURES
DEFROST OPERATION
If the ambient temperature of the
room in which the dehumidifier is
conditioning, falls below 15°C ice will
form on the evaporator coil as air
passes over it. Over a period of time
this build up of ice will effect the
efficiency of the dehumidifier on it’s
ability to maintain the required set
conditions within the room.
The BD150 is therefore fitted with a
defrost control device. This defrost
control device is timed to operate
every 42 minutes for a period of 4
minutes.
During the defrost cycle the high
pressure hot gas from the
compressor is diverted into the
evaporator coil where it melts the ice
which has formed on the evaporator
coil.
DUAL VOLTAGE MODELS
The BD150 dehumidifier unit is fitted
with a transformer which will allow
the unit to operate on either 110volts
or 230volts 1ph 50Hz power supply.
All electrical components within the
dehumidifier are rated for 110volts,
for safety reasons. The rotary switch
allows for the selection of the
required voltage prior to starting the
unit.
VOLTAGE PROTECTION
DEVICE
The dual voltageBD150 dehumidifier
unit is fitted as standard with a
unique voltage selection protection
device.
Should the unit be connected to
110volts supply and the rotary
selector switch set inadvertently to
230volts , the unit will not start.
This unit is fitted with a screw type in
line fuse holder with a 10 amp anti
fuse holder.