User's Manual

Attaching the Tether to the Pad and the Pen

The tether has a loop at each end. One end has a metal ring attached to the

loop – that’s the Pen loop. The other end is the Pad loop.

1 Thread the Pad loop up through the hole above the Pen Tray. Thread the

Pen loop through the Pad loop. Pull to tighten.

2 Thread the metal ring through the eyelet on the Pen.

Charging the InterWrite Pad and Pen

1 Set the InterWrite Pen into the Pen Tray with the Rocker Button facing up.

2 Connect the charger’s cable to the Power Jack at the top of the Pad.

3 Plug the charger into an AC power outlet.

The Pad can be used while it is charging.

4 When the Pad and Pen are charged and the Pad Battery Status Light goes

out, unplug the charger from the Pad.

The Electronic InterWrite Pen

The InterWrite Pen is an input device to the computer. You will use it to control mouse movements on the computer by moving the tip

of the Pen just above (in prox of), or touching, the Pad’s Workspace surface. When the tip of the Pen is in prox of, or on, the Pad’s

Workspace, it simulates the same effects you would see with the left mouse button both in Windows and on the Mac. When the Pen is

in prox, press the Rocker Button nearest the tip to simulate a left mouse button double-click in Windows and on the Mac. Press the

outside Rocker Button (the button farthest from the Pen Tip) to simulate a right mouse button click in Windows and a Ctrl-click on the

Mac. In Windows, hold down the left Rocker Button and touch the Pen Tip to the Pad’s Workspace to erase. On the Mac, with the Pen

Tip already touching the Pad’s surface, hold down the left button to erase.

The Pen goes into Sleep Mode after about two minutes of inactivity to conserve power. Touching the Pen to a surface, or clicking one

of its Rocker Buttons, wakes up the Pen. When the Pen is in prox, the Power Status Light on the Pad will go from flashing to solid

green. When the Pen is out of prox, the Power Status Light goes back to flashing green.

The Pen can be charged only when it is placed in the Pen Tray on the Pad, and the pad charger is plugged into the Pad. A Pen charge

lasts over 40 hours. Always charge the Pen when the Pad is being charged.

Electronic InterWrite Pen

Rocker Button

Pen Tip

Press for:

Right-click – Windows

Ctrl-click – Mac

Press for:

Double-click

(both Windows and Mac)