User's Guide

46 Chapter 3
Cycle
Response
Map Delay
(in seconds)
1 – 9
Option DescriptionSettings
This sets the amount of time, in seconds, the
current block of Response Boxes (set above) will
display before cycling to the next block.
Cycle
Response
Map Number
of Boxes
20 – 300 Set the number of Response Boxes that will
display during each Response Map Cycle.
Bottom Line
of Response
Box Shows
None
Clicker ID
Last 4 digits
Clicker ID
Last 2 digits
Clicker ID
If this Class definition has an associated Response
Map, you can choose what, if anything, will
display on the bottom line of each Response Box
in the Response Grid.
Cycle
Response
Map (if map
size is greater
than 50)
Yes/No If you have a large number of students in the
audience, you can set the Response Map to Cycle
Mode. When set to Yes, each block of Response
Boxes (defined next) will display for the amount of
time (Delay) set below before cycling through to
the next block in sequence. Cycling, when set,
continues throughout the Session.
You should always cycle the Response Map when
the defined number of Response Boxes is very
large. The Response Boxes in the Response Area
could be so small, they would be difficult to see
and read. Students would not be able to verify
receipt of their Response under such extreme
circumstances.
Classes – IR Class Settings
Grid Settings
Section
The options set in the Grid Settings section below the Response Map
Function Buttons pertain to the Response Map defined here. Each setting
is described in the table below.