User's Guide

28 Chapter 2PRS System Installation – Master RF Clicker
1 On the back of the RF Clicker, remove the Screw holding the Battery
Cover in place.
2 Remove the Battery Cover by pushing down on the Thumb Grip and
sliding it toward the bottom of the Clicker.
3 Remove the old batteries and discard them following the proper disposal
procedures.
4 Insert three AAA batteries, positioning them properly to ensure the
correct polarity.
5 Slide the Battery Cover back into place and replace the Screw.
Replacing
Clicker Batteries
Back of RF Clicker
Screw Battery
Cover
Thumb
Grip
When you see the Low Battery
message when you turn on your
RF Clicker, you have about 15%
Battery Life remaining. Replace
the batteries as soon as possible.
Master RF Clicker
Command Key
Assignments
COMMAND
Start Question
Resume Question
Pause Question
Stop Question
Increase Timer
Decrease Timer
Next Question
Previous Question
Close Chart
KEY
Master
Clicker
The Master RF Clicker is a special configuration of the RF Clicker that is
set using the Configuring Clickers option on the RF Menu. An RF Clicker
configured as a Master or Closed Master Clicker enables the instructor to
send commands to the PRS software during a Session and control the
presentation from anywhere in the room. The following table summarizes
the key assignments for an RF Clicker configured as a Master Clicker.