User Manual

Welcome Page 51 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
declares, that the product
conforms to the following product specifications:
Supplementary Information
The product herewith complies with the requirements of the EMC Directive 89/336/EEC.
European Contact
GTCO CalComp
World Trade Center
A-1300 Vienna -- Airport
Austria
Tel: + 43 1 7007 36450
Fax: + 43 1 7007 36458
European Union-emission directive
This product is in conformity with the protection requirements of EU Council Directive 89/366/ECC on the approximation of the laws of the
Member States relating to electromagnetic compatibility.
This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to CISPR
22/European Standard EN55022. The limits for Class B equipment were derived for typical industrial environments to provide reasonable
protection against interference with licensed communication devices.
Radio frequency emissions notices for MeetingBoard
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
n Reorient or coil cables.
n If necessary, consult the dealer or an experienced radio/television technician for additional suggestions.
Any cables the user adds to the device must be shielded to be in compliance with the FCC standards. Any unauthorized modification to
this device could result in the revocation of the end user’s authority to operate this device.
Electronic pen and eraser
Product Name:
MeetingPad 300, SchoolPad 300
Model Numbers:
Product Options:
All
Safety:
Not applicable to any standard.
EMC:
CISPR 22:1985/EN55022:1988-Class B
EN55024:1998
ETS 300 683 (1997)
ETS 300 220 (2000-09)
Scottsdale, Arizona, U.S.A. Mike Truscio
Location Date Vice President of Engineering