User Manual

Welcome Page 4 of 54

file://C:\TEMP\~hhA856.htm 8/12/02

Before unpacking, examine the shipping cartons for damage. If a carton is damaged, notify the shipper immediately.

Note: Save all shipping materials. If you need to ship a tablet later, you should repack it in the original materials.

2. Carefully unpack the products.

CAUTION: To avoid damage to the controller, do not rest the MeetingBoard tablet on the controller housing (located on the

rear of the tablet near one corner). Do not scratch or damage the tablet's writing surface.

3. Compare the parts with the appropriate parts checklist.

n Parts checklist for MeetingBoard and MeetingBoard LX.

n Parts checklist for MeetingPad 100

n Parts checklist for MeetingPad 300.

4. If anything is missing...

Immediately contact your GTCO CalComp supplier.

5. Activate your product warranty.

Complete the warranty registration card and mail it to GTCO CalComp If your product needs service, the card should be on file at

GTCO CalComp.

Next: Install InterWrite Software.

B. Install InterWrite Software

Note: InterWrite Software is compatible with Windows 95, 98, ME, NT, 2000 and XP.

1. Remove any graphic tablet drivers installed on the PC.

2. Insert the InterWrite Software CD into the computer’s CD drive.

3. Wait for the installation program to launch.

Note: If the installation program does not start on its own, use Windows Explorer to locate and launch setup.exe on the CD-

ROM.

4. Follow the on-screen instructions.

5. Check the Task Bar. If you don't see the InterWrite icon, restart the computer.

6. Click the InterWrite icon in the Task Bar, then click Check for Updates in the pop-up menu. If an update is available, download it

now.

Tip: Check for updates periodically.

Note: The first time you run InterWrite Software, you must enter the authorization code from the InterWrite Software License

Certificate.

If your system includes one or more MeetingPad 300s, recharge them now.

If your system doesn't include MeetingPads, Assemble MeetingBoard.

MeetingPad 300: recharge the tablet

Before initial use, recharge the MeetingPad 300 tablet for at least 3 hours.

1. Connect the charger’s cable to the POWER jack on the tablet.

2. Plug the charger into an AC power outlet.

Note: Do not operate the tablet while it is charging.

3. When charging is complete, unplug the charger from the power outlet, then disconnect the charger’s cable from the tablet.