User Manual

Welcome Page 24 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
To disassemble the pen: Press the latch on the underside of the pen, then pull the pen apart. The two modules should
separate easily---excessive force is not required and should not be used. If the modules don't separate easily, press the latch
farther inward.
Next: You are ready to connect the system.
Which mode should you use?
The mode you use depends on what you want to do with the School Suite system, as well as what hardware you have.
*Requires SchoolPad 300 and Bluetooth hub.
D Pen cap
Note: Keep the markers capped as much as possible to prevent them from drying out. The caps enable the electronic pens
to be used in Interactive Mode without leaving ink on the tablet.
d. Remove the battery cover from a pen electronics
module. Insert a battery into the module (assure polarity
is correct!). Replace the battery cover.
e. Snap the pen electronics module into a marker housing
(any module can be used with any marker housing).
f. The LED should flash four times, indicating the pen is
working correctly.
MeetingBoard electronic pen, assembled
What can you do? Interactive Mode PC Whiteboard Mode
Write using electronic ink
ü
Write from a wireless remote
tablet
ü*
Write with dry erase markers in
electronic pens
ü
Annotate PC screens
ü
Write meeting notes on a
"blank page"
ü ü
Review, rearrange or delete
annotation images
ü ü
Distribute annotation images
electronically
ü ü
Print notes Optional Optional