User Manual

Welcome Page 15 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
2. Assure other components are on:
n For Interactive Mode or PC Whiteboard Mode: Assure the computer is on.
n For Interactive Mode: Assure the video projector is on and is projecting the computer's screen onto the MeetingBoard writing
surface.
3. On the MeetingBoard LX control panel, use the electronic pen to...
Starting from a MeetingPad
Starting from a MeetingPad 100
1. Assure the MeetingBoard is on.
2. Assure the computer is on.
3. Using the pen, click the LAUNCH InterWrite spot in the upper right corner of the MeetingPad 100 tablet.
4. Choose a user profile:
a. Using the pen, click the e (in "InterWrite") in the upper left corner of the MeetingPad 100 tablet.
b. Click Yes in the dialog window, then select a user profile and log in.
Starting from a MeetingPad 300
Note:
n Up to 7 MeetingPad 300s can communicate with one Bluetooth hub.
n Each MeetingPad 300 must be within 25 feet (7m) of its intended Bluetooth hub. Reception depends on local conditions, and
performance may vary in your facility.
1. Assure the MeetingBoard is on.
2. Assure the computer is on.
3. Press the ON button on the MeetingPad 300. The discovery process will only find units that are on.
4. Using the computer's mouse, click the InterWrite icon in the Task Bar, then click Device Manager in the pop-up menu.
5. In the Bluetooth Device Discovery window, click the Discover Devices button. A list of found devices will appear.
6. For each device associated with the hub in this system, select the desired action for the device.
7. On the back of the MeetingPad 300, find the unit's address. In the Bluetooth Device Discovery window, open the list of found
devices, then click the corresponding device address.
Tip: To give a unit a unique name, select the unit in the list of found devices, then click the Properties button.
8. Choose a user profile:
a. Press the MeetingPad 300's LINK button.
b. Select a user profile and log in.
Tip: Once a MeetingPad 300 has been added via the Device Manager, it can be easily connected later from the Session
Manager (which reduces the number of steps needed to connect).
Note: If there is no pen activity for 30 minutes, the MeetingPad 300 will turn itself off to conserve its batteries. To begin using
the MeetingPad 300 again, press the ON button. You may need to use the device manager or session manager to relink the
tablet.
Starting from the PC
Click A for Interactive Mode.
Click B for PC Whiteboard Mode.