User Manual
- END –
Radio frequency emission notices
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Reorient or coil cables.
If necessary, consult the dealer or an experienced radio/television technician for
additional suggestions.
Any cables the user adds to the device must be shielded to be in compliance with the FCC
standards. Any unauthorized modification to this device could result in the revocation of the end
user’s authority to operate this device.
- END –
CE certification
Declaration of conformity according to ISO/IEC Guide 22 and EN 45014
Manufacturer’s Name: GTCO CalComp, Inc.
Manufacturer’s Address: 14555 N. 82nd Street
Scottsdale, Arizona 85260
U.S.A.
declares, that the product
Product Name: InterWrite MenuPad
Model Numbers:
Product Options: All
conforms to the following product specifications:
Safety: Not applicable to any standard.
EMC: CISPR22:1985/EN 55022:1988--Class B
EN 55024:1998
ETS 300 683 (1997)
ETS 300 220 (2000-09)
Supplementary Information
The product herewith complies with the requirements of the EMC Directive 89/336/EEC.