User Manual

GB
- 16 -
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
The base frame must be placed on a fl at and
clean surface.
Whenever you use this crosscut saw base frame,
always secure the device with all four screws. Do
not exceed the maximum permissible load for the
base frame. Observe the general safety principles
for woodworking equipment. Follow the original
operating instructions and the safety information
for the device which you use in combination with
the base frame.
2. Layout and items supplied
2.1 Layout (Fig. 1, 2)
1.a) Clamping device on left
1.b) Clamping device on right
2. Guide rails
3. Arm
4. Locking lever
5. Clamp lever
6. Foot
7. Plastic foot
8. Plastic nut
9. Locking grip
10. Guide roller
11. Lever
12. Adjusting screw
13. Lock nut
14. Extension plate
15. Lock bolt
16. Nut for extension
17. Socket head screw (short)
18. Socket head screw (long)
19. Spring washer
20. Washer
21. Fastening nut
22. Storage box
23. Workpiece support
24. Transport handle
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Clamping device (2x)
•
Locking grip (2x)
•
Guide roller (2x)
•
Extension plate (2x)
•
Lock bolt (2x)
•
Nut for extension (2x)
•
Socket head screw (short) (4x)
•
Socket head screw (long) (4x)
•
Spring washer (4x)
•
Washer (6x)
•
Original operating instructions
Anl_MSS_1610_SPK9.indb 16Anl_MSS_1610_SPK9.indb 16 14.11.2018 08:16:1314.11.2018 08:16:13