User Manual

GB
- 17 -
the gear unit when you change the blade. To as-
semble, proceed in reverse order.
When you fi t the hedge cutter blade
check the position of the pin for the eccentric con-
nector (Fig. 7/Item 1). Take the hedge cutter blade
and slide the eccentric mount (Fig. 8/Item 1) into
position so that the pin for the eccentric connector
and the eccentric mount fi t together precisely
when assembled. Slot the hedge cutter blade
onto the guide pins (Fig. 7/Item 2).
When you fi t the grass cutter blade
check the position of the pin for the eccentric
connector (Fig. 7/Item 1) again. Shift the eccentric
mount (Fig. 9/Item 1) on the grass cutter blade to
the left or the right to fi nd the position at which the
pin for the eccentric connector (Fig. 7/Item 1) and
the eccentric mount (Fig. 9/Item 1) match up.
7. Cleaning, maintenance and
ordering of spare parts
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth. Do not use cleaning agents or solvents;
these could attack the plastic parts of the
equipment. Ensure that no water can seep
into the device. The ingress of water into an
electric tool increases the risk of an electric
shock.
•
A few drops of oil (e.g. sewing machine oil)
will improve the cutting performance of the
blades, but never apply any grease to the bla-
des. To ensure constant exact cutting it is also
important to remove grass remnants and dirt
from between the upper and lower blade.
Important!
Never clean the tool under running water
- and particularly never with high pressure -
because of the potential danger to persons
and property. Keep your cordless grass
cutter and hedge trimmer in a dry and frost-
proof place. Choose a place that children are
unable to enter.
7.2 Maintenance
•
To achieve good results you should keep the
blades sharp at all times. In particular we re-
commend that you immediately level off any
jags or ridges caused by stones or the like.
The tool should be thoroughly cleaned both
before and after use.
•
There are no parts inside the equipment
which require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Grass cutter blade: 341044001001
Hedge cutter blade: 341044001002
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_GC_CG_3_6_Li_SPK9.indb 17Anl_GC_CG_3_6_Li_SPK9.indb 17 30.03.2017 13:50:0430.03.2017 13:50:04