User manual

 Hazard due to wood dust: The inhalation of
wood dust is a health hazard! Always wear a
protective dust mask when emptying the debris
bag. When disposing of sawdust waste, make
sure you do so in an environmentally-friendly
fashion!
 Fire hazard: Never use the machine to extract
hot objects!
 Damage to hearing if ear-muffs are not used as
necessary.
 Harmful emissions of wood dust when used in
closed rooms.
4. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
 CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
5. Technical data
Motor 220-240 V ~ 50Hz
Motor speed n
0
2900 rpm
Power P 550 W
Protection type IP 20
Max. vacuum 1600 Pa
Max. extraction volumes 1150 m
3
/h
Extractor socket 100 mm
Sawdust bag volumes 65 l
Weight 22,5 kg
Noise
Sound and vibration values were measured in
accordance with EN 60335-2-69.
L
pA
sound pressure level 75,5 dB(A)
L
WA
sound power level 95,5 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Keep the noise emissions and vibrations to a
minimum.
 Only use appliances which are in perfect working
order.
 Service and clean the appliance regularly.
 Adapt your working style to suit the appliance.
 Do not overload the appliance.
 Have the appliance serviced whenever
necessary.
 Switch the appliance off when it is not in use.
6. Before starting the equipment
앬 Unpack the vacuum extraction system and
check it for damage which may have occurred in
transit.
앬 The machine has to be set up where it can stand
securely. All covers and safety devices have to
be properly fitted before the machine is switched
on.
앬 Before you actuate the On/Off switch, make sure
that the debris bags are securely fastened!
앬 Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
7. Assembly (Fig. 1, 3-15)
Important. Pull out the power plug before
carrying out any maintenance, resetting or
assembly work on the vacuum extraction
system!
앬 Undo the two nuts (E) on both sides of the plastic
housing (13) (Fig. 3).
앬 Guide the side plates (12) over the screws on the
plastic housing (13) and secure them with the
nuts (E) (Fig. 4-5).
앬 Place the strengthening plate (9) between the
side plates (12) and secure it with the screws (B)
and nuts (C) (Fig. 6).
앬 Secure the chassis (8) to the side plates (12)
using the screws (D) and nuts (C) (Fig. 7).
앬 Now thread the quick-release device (3) through
the sewn-in guide in the dust bag (2) (Fig. 8-9).
앬 Place the dust bag hook (1) into the hole for the
dust bag hook (14) on the plastic housing (13)
and attach the dust bag (2) to the dust bag hook
(1) (Fig. 10).
앬 Snap the dust bag (2) over the top opening in the
plastic housing (13) so that it completely
surrounds the opening and secure it using the
quick-release device (3) (Fig. 11).
14
GB
Anleitung_RT_VE_550_SPK1:_ 27.11.2009 8:04 Uhr Seite 14