Instruction Manual

Remote controller
INSTRUCTION OF INSTALLATION AND OPERATION
1.
INSTALLING RECEIVER IN CEILING FAN
A. Safety precautions
1. WARNING: HIGH VOLTAGE! Disconnect power by
removing fuse or switching off circuit breaker.
2. Do not use with solid state fans.
3. Electrical wire must meet all local and national
electrical code requirements.
4. Supply for fan must be 110/120 volt, 60Hz, 3.5A
5. Maximum fan motor amps: 1.0.
6. Maximum light watts: 180 incandescent or ballast and
LED.
7. To Reduce the risk of shock, this fan must be installed
with a wall switch/control.
B. Installing receiver in fan
1. Remove power from the circuit.
2.Remove ceiling fan canopy from the mounting
bracket.
3.Disconnect existing wiring between ceiling fan
and Supply in electrical junction box.
4.Make connections as follows, using the wire nuts
supplied.
CAUTION: Ceiling Angle Shall Not Exceed 30 Degrees, For
MountingController,Model:
CONNECT TO
Green fan wire...... Bare supply wire
Red or Black receiver wire(AC IN L) ....Red or Black supply wire
White receiver wire(AC IN N)...... White supply wire
White receiver wire(TO MOTOR N)...... White fan wire
Black receiver wire(TO MOTOR L)
......
Black fan wire
Blue receiver wire(FOR LIGHT)
......
Blue light wire
FROM POWER SOURCE
AC 110~120 VOLT 60Hz
3.5AMPS.
Use wire connecting nuts supplied with the fan
(FIG.3)
RECEIVER
(FIG.4)
ANTENNA PUT AT OUTSIDE
OF CANOPY BOX CAN GET
MORE OPERATION
DISTANCE
CANOPY
LIGHT MUST BE KEPT AT THE ON POSITION
F A N M U S T B E K E P T A T T H E H I G H S P E E D
If other fans or supply wires are different color, have this unit installed by qualified licensed electrician.
a. Push all connected wires up into junction box.
b. Lay the brown antenna wire on top of the receiver, and put the receiver into the mounting bracket.
c. Reinstall the canopy on the mounting bracket.
d. Restore power.
e.
f. Store the transmitter away from excessive heat or humidity.
g. This remote control unit is equipped with roll code combinations. In order to prevent possible interference from or to
other remote units such as garage door openers, car alarm or security system. If you find that your fan and light kit go on
and off without using your remote control, simply change the code combination in your transmitter and receiver
WHITE
INPUT
RED or BLACK
ANT
OUTPUT
WHITE
BLUE
WHITE
BLUE
WIRE NUT
Use wire connecting nuts
supplied with the remote
controller.
CANOPY
REC
EIVER
AC N
AC L
AN T
CO M
FAN
LI G H T
INPUT
OUTPUT
RECE IVE R
FIG1
TRANSMITTER
LEARN
CODE
CO M
CO DE
REV
PURPLE
PURPLE
. Install
3 volt battery(not included). (To prevent damage to transmitter, remove the battery if not used for a long time).
RE-028W